BNC male to 2 pin terminal Block VIDEO INPUT (BNC Connector): 1
>>>VIDEO INPUT: 1V p-p, 75 Ohms DIMENSIONS W x H x D mm: 69x25x22
TTP111VPK
Video & Power Transceiver DIY KIT ( TTP111VP + TTP111VPJ) in blister card pacakge
Transmit video and power over one CAT5 networking cable. Eliminate coaxial cable. Fast, easy installation, saving time and money. Substantial saving on the costs of the cable itself.
TTP414V
4 Channel Video Transceiver
4 x BNC female to 1 x RJ45 female + 8 pin terminal block. Four passive transceivers in one product. Choice or RJ45 or push pin terminal inputs/outputs.
Active Series ------
TTA111V
4 Channel Video Transceiver
Three position range switch for gain select on transmitter. Five position distance range switch on Receiver, brightness adjustment, two video output. Built in transient protection and ground lifting. System is integrated with alarm sensor (PIR, Magnetic, etc...) or RS485/422 data.
Panel ------
TPP016
16 Port Passive Video Transceiver Hub in 1U Rack Mounting Panel
Built in 16 port passive transceivers in 1U 19" rack mounting panel. As a rack mounting passive transmitter hub, use with active receiver at distance up to 1000 meters. Passive, no power required. Built in a highly balanced mode of video transmission for extra interference immunity.
TPA016
16 Port Active Receiver Hub In 1U Rack Mounting Panel
Built in 16 port TTA111VR active receivers in 1U 19" rack mounting panel. Built in a highly balanced mode of video transmission for extra interference immunity. Built in transient protection and ground lifting.
Video Input Port :16 Port (Terminal Block)
Video Output Port (BNC Connector): 16 Port, 1Vp-p, 75 ohms
Power Input: DC12V
Power Consumption: 500mA
Recommend Cable: CAT 5 Cable 4 Pairs (24 AWG)
Dimension W x H x D mm: 482x170X44 (1U)
Weight: 2720 g
Material: Metal Black
PTZ Controller------
PCR011
PTZ Receiver
Built in PELCO D protocol. PAN & TILT control. Lens control: zoom, focus. 1 Auxiliary Relay provide for any desired functions: alarm, wash/wipers, lighting. Easy addressed code setting. (00-99). Allows the pan tilt power AC110V/220V/24V, zoom lens power DC12 or 6V (2A-Max.). Built in surge protection. Support all pan, tilt, zoom lens. Low Cost, economic type. Easy wiring.
PCR017
PTZ Receiver IP65 Weatherproof case
Built in PELCO D protocol. Identical same as above PCR011 but Lens control: zoom, focus, iris. IP65 Weatherproof case. 3 Auxiliary Relay provide for any desired functions: alarm, wash/wipers, lighting.
RS001
RS232 TO RS485 CONVERTER
DB9 female connector for RS232 to 2 wires Terminal Block for RS485. Two wire, differential signals, half duplex. Non power operation. Auto switching baud rate, speed up to 115,200 baud over a distance 1200 meters 32 units connected together in RS-485 multidrop operation.
Twisted Pair 
BNC male to 2 pin terminal Block
